Wheel ring set (4pc)

This set consists of four outer hub cap rings for the two-piece hub caps. Each ring is supplied with the mounting clips already installed, allowing a straightforward push-on installation.

Original rings are no longer available and good used examples have become increasingly difficult to source.

Please note that these rings are aftermarket reproductions and differ slightly from the original design. A comparison photo below shows the difference between the original rings and these replacements.

The rings are known to fit tightly on the wheel rim. For installation, we recommend removing the wheel and placing it flat on the floor. The trim ring should then be carefully positioned and gradually pressed onto the rim, ensuring it contacts the rim evenly around its circumference. A final firm push is required to seat the ring fully. For best results and to achieve an even fit, this step should ideally be carried out by two people.