RH13076-KT-BR is supplied as a set of two gaskets that can be fitted to the existing spacer, which in most cases remains serviceable.
You will need 2 sets gaskets per car

The original part RH13076 is made up of a spacer with gaskets bonded to both sides.

This kit includes seals for two cylinders
There are two cylinders per wheel

Front calipers needs two gallery seals per caliper.
Rear calipers have two gallery seals per caliper.

Early front calipers (for solid brake discs) need one gallery seal per caliper.
Later front calipers (for vented brake discs) needs two gallery seals per caliper.
All rear calipers have two gallery seals per caliper.

Arnage T and Silver Seraph models require two filters per car

This is the gearbox filter (GM6437741), sump gasket (GM8629807) and two strainer o rings (GM6437746)

Reconditioned and reprogrammed 433 MHz (European specification) alarm ECU, supplied complete with two new remote key fobs.

The kit contains the main plug UR4064, the pin UR4083, spring RF7552, spring seat RF7556, ball bearing RF8789 and two shims.

Required quantity per car: 2 pcs

rom 1990-1994 approx (Please confirm with chassis number)

rom 1990-1994 approx (Please confirm with chassis number)

On early vehicles, two different versions are available. This version can be identified by the rubber inner bellows with 3 convolutions. It is suitable for driveshafts with part numbers 3W0407271B or 3W0407272B.

There are two fitted on the car. 

This is the main alarm ECU. It's located under the dashboard.

This is a set of four outer hub cap rings for the 2 piece hub caps. The rings come with mounting clips already attached so they are straight push-on fit.

We recommend that you also require two sealing rings CD6106.

This Fuel Pump is the left hand of the two pumps (when viewed as if sitting in the car). 

When replacing the fuel pump it is essential to clean the fuel tank & flush the system as part of the procedure.

Arnage T and Silver Seraph models require two filters per car

There is one per side so two will be required, they do not come with the brake pads

There is one per side so two will be required, they do not come with the brake pads

This kit includes 

• 1xUE35892-BR filter
• 1xUA11658-BR o-ring
• 2xUD11425-BR o-ring

Two kits are fitted per car

There are two types of connector, the previous solenoid was supplied with a 2 pin connector, whereas this superseded number is supplied with a 3 pin connector. If you are fitting to a 2 pin connector vehicle then please reuse the old connector. 

On early vehicles, two different versions are available. This version can be identified by the rubber inner bellows with 3 convolutions. It is suitable for driveshafts with part numbers 3W0407271B or 3W0407272B.